VACUUBRAND PC 3001 VARIOpro emission condenser Peltronic - Manual (Page 30)

page 30 of 120
Gas inlet temperatures
Wetted parts
Components Wetted materials
Pump
Housing cover PTFE
Head cover ETFE carbon fiber reinforced
Diaphragm clamping disc ETFE carbon fiber reinforced
Diaphragm PTFE
Valve FFKM
Pumping unit
Inlet pumping unit
PPS (PC 3001 VARIO pro IK: PP)
Outlet pumping unit
PET (PC 3001 without emission con-
denser: PTFE carbon reinforced)
Outlet pumping unit (PC 3001 VARIO pro
emission condenser Peltronic)
ETFE / ECTFE
Tubing PTFE
Screw-in fittings ETFE / ECTFE
O-ring at the catchpot Fluoroelastomer
Overpressure safety relief device
at exhaust waste vapor condenser
Silicone rubber / PTFE film
Distribution head (inlet)
PPS glass fiber reinforced /
PP (blind plug)
Waste vapor condenser IK / EK / TE,
catchpot
Borosilicate glass
Emission condenser Peltronic ETFE / ECTFE / PP / PA
Silencer PBT / PVF / rubber
CVC 3000
Sensor Aluminum oxide ceramic
Sensor housing PPS / glass fiber
Sensor seal Chemically resistant fluoroelastomer
Venting valve seal FPM
We reserve the right for technical modification without prior notice!
* if pumping potentially explosive atmospheres: 50 °F to 104 °F (+10°C to +40°C)
Operating condition Inlet pressure
Permitted range of gas
temperatures at inlet
Continuous operation
> 75 Torr (100 mbar)
(high gas load)
➨
50 °F to 104 °F
(+10°C to +40°C)
Continuous operation
< 75 Torr (100 mbar)
(low gas load)
➨
32 °F to 140 °F*
(0°C to +60°C*)
Short-time
(< 5 minutes)
< 75 Torr (100 mbar)
(low gas load)
➨
14 °F to 176 °F*
(-10°C to +80°C*)