R electrical information, F. electrical information – ADC AD-78 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
R ELECTRICAL INFORMATION
1. Electrical Requirements
It is your responsibility to have ALL electrical connections made by a properly licensed and competent
electrician to assure that the electrical installation is adequate and conforms with local and state regulations
or codes. In the absence of such codes, ALL electrical connections, material, and workmanship must
conform to the applicable requirements of the National Electrical Code ANSI/NFPA NO.70-LATEST
EDITION..
IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements
stipulated in this manual can result in personal injury or component failure.
I
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
J
Each dryer should be connected to an independently protected branch circuit. THE DRYER MUST BE
CONNECTED WITH COPPER WIRE ONLY. DO NOT use aluminum wire which could cause a fire
hazard. The copper conductor wire/cable must be of proper ampicity and insulation in accordance with
electric codes for making ALL service connections.
NOTE: The use of aluminum wire will VOID THE WARRANTY.
I IMPORTANT: A separate circuit servicing each dryer must be provided.
|
19