ADLINK ND-6054 - Manual (Page 79)

Command Set • 71
3.9 Digital Output (Continued)
( 6056, 6058 )
@Description
Set digital output channel value at specified address. This command is only
available to modules involving the multiport digital output function.
@Syntax
#(Addr)T(OutDataH)(OutDataL)<CR> (6056 only)
#(Addr)T(OutDataA)(OutDataB)(OutDataC) (6058 only)
# Command leading code. (1-character)
(Addr) Address ID (2-character)
T Set value to all channels
(OutDataH)
Each bit is mapping to each channel number from 14
to 8. (2-character)
(OutDataL)
Each bit is mapping to each channel number from 7 to
0. (2-character)
(OutDataA)
Output data for port A. Each bit is mapping to each
channel number from 7 to 0. (2-character)
(OutDataB)
Output data for port B. Each bit is mapping to each
channel number from 7 to 0. (2-character)
(OutDataC)
Output data for port C. Each bit is mapping to each
channel number from 7 to 0. (2-character)
* if the port of ND-6058 is in input mode, output data to this port will be
ignore.
@Response
<CR>
or
?(Addr)<CR>
> Command is valid
? Command is invalid.
(Addr) Address ID.