ADLINK ND-6054 - Manual (Page 96)

88 • Command Set
3.16 Change Leading Code Setting
( 6050, 6052, 6053, 6054,
6056, 6058, 6060, 6063 )
@Description
User can use this command to change command leading code setting as he
desired.
@Syntax
~(Addr)10(C1)(C2)(C3)(C4)(C5)(C6)<CR>
~ Command leading code.
(Addr) Address ID, range (00 - FF).
10 Change command leading code setting.
(C1)
Leading code 1, for read configuration status,
firmware version, etc. default is $.
(1-character)
(C2)
Leading code 2, for read synchronize sampling,
digital output ,default is #. (1-character)
(C3)
Leading code 3, for change configuration.
default is %. (1-character)
(C4)
Leading code 4, for read alarm status, enable
alarm, etc. default is @. (1-character)
(C5)
Leading code 5, for read command leading
code, change leading code, etc. default is ~.
(1-character)
(C6)
Leading code 6, this leading code is reserved.
default is *. (1-character)
@Response
!(Addr)< CR>
or
?(Addr)<CR>
! Command is valid.
? Command is invalid.
(Addr) Address ID.