Dunkirk Q95M-200 Modulating Condensing Boiler User Manual

Page 24

Advertising
background image

13.3 To Turn Off Gas To Appliance
1.

Set thermostat to lowest setting.

2.

Turn off all electric power to appliance if service is to be

performed.

3.

Remove front jacket panel.

4.

Turn gas ball valve off, handle should be perpendicular

to gas pipe.

5.

Replace front jacket panel.

13.2 Operating Instructions
1.

Set thermostat to lowest setting.

2.

Turn off all electrical power to appliance.

3.

Boiler does not have a pilot. It is equipped with ignition

device which automatically lights burner. Do not try to

light this burner by hand!

4.

Remove front jacket panel.

5.

Turn off gas ball valve. Valve handle should be

perpendicular to gas pipe.

6.

Wait 5 minutes for any gas to clear. Then smell for gas,

including near floor. If you smell gas, STOP! Follow

instructions on previous page “What To Do If You Smell

Gas.” If you do not smell gas, go to next step.

7.

Turn gas ball valve to “on” position. Handle on valve

should be parallel to gas pipe. See Figure 12.

8.

Replace front jacket panel.

9.

Turn on all electrical power to appliance.

10.

Set thermostat to desired setting.

11.

If boiler will not operate, follow instructions “To Turn

Off Gas To Appliance” and call your service technician

or gas supplier.

13 - OPERATING INSTRUCTIONS

Control Valve “ON”

Control Valve “OFF”

Figure 12 - Gas Valve

13.1 Lighting Instructions

For Your Safety Read Before Operating!!

WARNING

If you do not follow these instructions

exactly, a fire or explosion may result

causing property damage, personal injury

or loss of life.

• This appliance is equipped with an ignition device

which automatically lights burner. Do NOT try to

light this burner by hand.

• Before operating smell all around appliance area

for gas. Be sure to smell next to floor because

some gas is heavier than air and will settle to the

floor.

• Use only your hand to turn the gas shutoff

valve. Never use tools. If valve will not turn

by hand, do not try to repair it, call a qualified

service technician. Force or attempted repair may

result in fire or explosion.

• Do not use this appliance if any part has

been under water. Immediately call a qualified

service technician to inspect appliance and to

replace any part of control system and any gas

control which has been under water.

!

Stop! Read Safety information above.

CAUTION

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electrical switches; do not use

any phone in your building.

• Immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s

instructions.

• If you cannot reach your gas supplier, call the fire

department.

!

24

Advertising