East Coast Supercharging ECS Paxton SC1500 2010+ Camaro Supercharger Kit - Manual (Page 23)

Remove inner quarter panel by pulling
towards center of car, exposing the fuel pump
control module
Mount Boost a pump securely to floor board, under
rear seat as shown.
Cut sheathing to expose red and white
fuel pump power feed wire
Splice red and white approximately two inches
out from plug, strip both ends.
Take fused red power wide from Boost a Pump
to red and white factory harness furthest from
the plug
Take second red wire from boost a pump and
splice to other end of red and white fuel pump
power feed wire – closest to the plug.
Locate the red and white fuel pump power wire coming from the FPCM plug. Cut and
splice two inches from plug.
Using supplied hardware, mount ECS BAP to the
floor right below the FCPM as shown.