East Coast Supercharging ECS Paxton SC1500 2010+ Camaro Supercharger Kit - Manual (Page 24)

Using supplied connectors, connect the
orange wire from BAP to the plug side of the
red and white wire going to the FCPM. Next,
take the red fused wire from the BAP and
connect to the red and white wire end going
towards the fuel pump.
Route remaining wires towards front of car
along the factory wiring. Find a suitable
location and ground the black wire from the
BAP.
Route the remaining brown wire from the BAP
to the engine bay and find a suitable location
for the supplied hobbs switch near a vacuum
source and install the supplied vacuum tee
to the ECS supplied vaccum manifold on the
brake booster. The remaining brown wire from
the ECS BAP goes to one of the hobbs switch
terminals. It does NOT matter which one as
it reverse polarity. Using the extra supplied
ground wire and terminals, run a ground up
to the other hobbs switch terminal and to a
suitable location.