Echelon IzoT NodeBuilder - Manual (Page 46)

• If you are using the NodeBuilder FX/PL hardware (LTM-10A Platform with Gizmo 4 I/O
Board), select LTM-10A RAM in the Development Build Hardware Template property,
and then select LTM-10A Flash in the Release Build Hardware Template property.
8. Click Finish. The NodeBuilder Code Wizard starts. There will be an initial pause as it reads the
available resource files. Proceed to the next section to generate Neuron C code that defines your
device’s interface.
32 IzoT NodeBuilder Quick-Start Exercise