Altera MAX 10 FPGA - Manual (Page 44)

• JEDEC STAPL Format ( .jam )
• Jam STAPL Byte Code ( .jbc )
• Serial Vector Format ( .svf )
10.Type the file name in the File name field, or browse to and select the file.
11.Click OK to generate the
.jam , .jbc or .svf file.
Programming .ekp File and Encrypted POF File
There are two methods to program the encrypted .pof and .ekp file:
• Program the .ekp and .pof separately.
• Integrate the .ekp into .pof and program both altogether.
Programming .ekp File and Encrypted .pof Separately
To program the .ekp and encrypted .pof separately using the Quartus II software, follow these steps:
1. In the Quartus II Programmer, under the Mode list, select JTAG as the programming mode.
2. Click Hardware Setup and the Hardware Setup dialog box will appear.
3. Select USBBlaster as the programming hardware in the Currently selected hardware list and click
Done.
4. Click Add File and the Select Programmer File dialog box will appear.
5. Type
<filename>.ekp
in the File name field and click Open.
6. Select the
.ekp file you added and click Program/Configure.
7. Click Start to program the key.
Note: The Quartus II software message window provides information about the success or failure of
the key programming operation. Once the .ekp is programmed, .pof can be programmed
separately. To retain the security key in the internal flash that had been programmed through
the .ekp , continue with the following steps.
8. Select the
.ekp to be programmed to the selected device.
9. Check only the functional block that need to be updated at child level. Do not check operation at the
parent level when using Programmer GUI.
10.After all settings are set, click Start to start programming.
Integrate the .ekp into .pof Programming
To integrate the .ekp into .pof and program both altogether using the Quartus II software, follow these
steps:
1. In the Quartus II Programmer, under the Mode list, select JTAG as the programming mode.
2. Click Hardware Setup and the Hardware Setup dialog box will appear.
3. Select USBBlaster as the programming hardware in the Currently selected hardware list and click
Done.
4. Click the Auto Detect button on the left pane.
5. Select the .pof you wish to program to the device.
6. Select the
<yourpoffile.pof> ,
right click
and select Add EKP File to integrate .ekp file with the .pof
file.
3-14 Programming .ekp File and Encrypted POF File
UG-M10CONFIG
2015.05.04
Altera Corporation MAX 10 FPGA Configuration Design Guidelines
Send Feedback