Altera Phase-Locked Loop Reconfiguration IP Core - Manual (Page 17)

Design Example Page 17
Phase-Locked Loop Reconfiguration (ALTPLL_RECONFIG) Megafunction February 2012 Altera Corporation
7. Click Finish. The reconfig_pll module is built.
8. Click OK. The MegaWizard Plug-In Manager resets to page 2a to allow you to
create a new custom megafunction variation.
9. In the MegaWizard Plug-In Manager pages, select or verify the configuration
settings listed in Table 5 . Click Next to advance from one page to the next.
10. Click Finish. The pll_reconfig module is built.
Summary
Variation file Turned on
PinPlanner ports PPF file Turned on
AHDL Include file Turned on
VHDL component declaration file Turned on
Quartus II symbol file Turned on
Instantiation template file Turned on
Table 4. Configuration Settings for the ALTPLL Megafunction (Part 2 of 2)
MegaWizard
Plug-In Manager
Page
Settings Value
Table 5. Configuration Settings for the ALTPLL_RECONFIG Megafunction
MegaWizard
Plug-In Manager
Page
Settings Value
2a
Megafunction Under the I/O category, select ALTPLL_RECONFIG
Which device family will you be using? Stratix
Which type of output file do you want to
create?
VHDL
What name do you want for the output file? pll_reconfig
Return to this page for another create
operation
Turned off
Parameter Settings
(General)
Currently selected device family Stratix
Match project/default Turned on
Which scan chain type will you be using Long chain
Parameter Settings
(General)
Do you want to specify initial value of the
scan chain?
Select Yes, use this file for the content data
File name pll_j1__pll.mif
Do not use pre initialized RAM - initialize
from ROM instead
Turned off
EDA Generate netlist Turned off
Summary
Variation file Turned on
AHDL Include file Turned on
VHDL component declaration file Turned on
Quartus II symbol file Turned on
Instantiation template file Turned on