Restoring the factory design to the flash device – Altera Embedded Systems Development Kit, Cyclone III Edition User Manual
Page 27
3–5
Development Board Version 1.0.
Altera Corporation
Altera Embedded Systems Development Kit, Cyclone III Edition
July 2010
Restoring the Factory Design to the Flash device
9.
Click Start to download the selected configuration file to FPGA.
When the progress bar reaches 100% the FPGA is ready to access
and program the Flash device
You have now successfully programmed the flash device with a
configuration for your board. To configure the board form the flash
device, power cycle the board. Powering on the board causes the flash
device to load a new configuration into the FPGA. The CONF DONE LED
lights up and the hardware functions associated with the design take
effect.
Restoring the
Factory Design
to the Flash
device
To restore the development board to factory conditions, refer to
instructions as described in