Altera Transceiver Signal Integrity Development Kit, Stratix IV GX Edition - Manual (Page 22)

2–12 Chapter 2: Board Components
Configuration, Status, and Setup Elements
Transceiver Signal Integrity Development Kit, November 2011 Altera Corporation
Stratix IV GX Edition Reference Manual
Table 2–6 lists the surface mount LEDs which indicate the various status of the board.
Board Jumpers
Table 2–7 lists the board jumper references, names, and functional descriptions.
D21 DUPLEX Green LED. Illuminates to indicate Ethernet full duplex status.
D22 1000 Green LED. Illuminates to indicate Ethernet linked at 1000 Mbps.
D23 100 Green LED. Illuminates to indicate Ethernet linked at 100 Mbps.
D24 10 Green LED. Illuminates to indicate Ethernet linked at 10 Mbps.
Table 2–5. Board-Specific LEDs (Part 2 of 2)
Board
Reference
LED Name Description
Table 2–6. Status LEDs
Board
Reference
Description
Schematic
Signal Name
I/O Standard
Stratix IV GX
Device
Pin Number
Other
Connections
D3 Power LED 5V — — —
D17 FACTORY LED FACTORY_IMAGE 2.5-V CMOS — U32 pin R8
D18 USER LED USER_IMAGE 2.5-V CMOS — U32 pin R7
D16 ERROR LED CONFIG_ERR 2.5-V CMOS — U32 pin R9
D19 Ethernet transmit activity LED ENET_LED_TX 2.5-V CMOS — U40 pin 68
D20 Ethernet receive activity LED ENET_LED_RX 2.5-V CMOS — U40 pin 69
D21 Ethernet Full-Duplex LED ENET_LED_DUPLEX 2.5-V CMOS — U40 pin 70
D22 Ethernet 1000-Mbyte Link LED ENET_LED_LINK1000 2.5-V CMOS — U40 pin 73
D23 Ethernet 100-Mbyte Link LED ENET_LED_LINK100 2.5-V CMOS — U40 pin 74
D24 Ethernet 100-Mbyte Link LED ENET_LED_LINK10 2.5-V CMOS — U40 pin 76
D6 Over-Temperature LED FAN_LED 2.5-V CMOS U33 pin F14 —
D7 USB-Blaster activity LED USB_LED 3.3-V CMOS — U17 pin 8
Table 2–7. Board Jumpers (Part 1 of 2)
Board
Reference
Jumper Name Description
J6 VCCA_SEL
When a jumper is installed on pins 1-2, VCCA is set to 2.5 V.
When a jumper is installed on pins 2-3, VCCA is set to 3.0 V
J11 VCCH_SEL
When a jumper is installed on pins 1-2, VCCH is set to 1.4 V.
When a jumper is installed on pins 2-3, VCCH is set to 1.5 V
J26
MAXII
BYPASS
When a jumper is installed, the MAX II CPLD device (U32) is included in the JTAG
programming chain.
When a jumper is removed, the MAX II CPLD device (U32) is removed from the JTAG
programming chain.
J62 PGMSEL
When a jumper is installed on pins 1-2, FPP configuration loads the user POF image
from flash.
When a jumper is installed on pins 2-3, FPP configuration loads the factory POF image
from flash.