Moving the auto access seat outside the vehicle – TOYOTA 2011 Sienna User Manual
Page 70
26
1-2. Operating the AUTO ACCESS SEAT
SIENNA AAS_U (OM45460U)
Moving the AUTO ACCESS SEAT outside the vehicle
Park the vehicle on a flat surface and leave the engine run-
ning.
Shift the shift lever to P and set the parking brake.
Confirm the following:
• The occupant is sitting correctly in the AUTO ACCESS
SEAT. (
→P. 14)
• The seat belt is not caught up in the AUTO ACCESS
SEAT.
• The occupant of the right-hand third seat is safe.
• The condition of the AUTO ACCESS SEAT (
→P. 20)
Open the right-hand sliding door fully.
Fold the front passenger seatback while pulling the seat-
back angle lever. (
Remove the wireless remote
control from the AUTO
ACCESS SEAT.
Press and hold the seat lower
switch on the wireless remote
control to rotate and lower the
AUTO ACCESS SEAT.
Operation can also be carried
out by the seat raise/lower
switch. (
STEP
1
STEP
2
STEP
3
STEP
4
STEP
5
STEP
6
STEP
7