BIXOLON SRP-150 - Manual (Page 38)

Rev. 1.08 - 38 -
SRP-150
① GS V m ② GS V m n
[Name] To Select cut mode and cut paper
[Type] ① ASCII GS V m
HEX 1D 56 m
DECIMAL 29 86 m
② ASCII GS V m n
HEX 1D 56 m n
DECIMAL 29 86 m n
[Range] ① m = 1, 49
② m = 66, 0 ≤ n ≤ 255
[Description] Selects a mode for cutting paper and executes paper cutting.
The value of m selects the mode as follows.
m Print Mode
0, 1, 49 Partial cut (one point center uncut)
66
Feeds paper (cutting position + [n x )vertical motion unit)]),
And cuts the paper partially (one point center uncut).
GS W nL nH
[Name] To set the printing area
[Type] ASCII
GS W nL nH
HEX 1D 57 nL nH
DECIMAL 29 87 nL nH
[Range]
0 ≤ nL ≤ 255 , 0 ≤ nH ≤ 255
[Description] Printing area is accurately set by nL and nH.
Printing area is set to [(nL + 256 x nH) x horizontal motion unit] inches.
Printable area
Left Margin Printing area width
GS ^ r t m
[Name] To run the macro
[Type] ASCII
GS ^ r t m
HEX 1D 5E r t m
DECIMAL 29 94 r t m
[Range] 0 ≤ r ≤ 255 , 0 ≤ t ≤ 255 , 0 ≤ m ≤ 1
[Description] To run the macro
- r: Repetition frequency of macro execution.
- t: Delay time for executing all macros is t X 100 msec.
- m: Macro execution mode
LSB of m = 0
Macros will be executed r times continuously with a delay time of t.
LSB of m = 1
After waiting for the delay time t, paper out LED indicator blinks, and the
printer is in standby until the feed button is pressed. One the button is
depressed, the printer executes the macro once. And this operation is
repeated r times.