Xtramus NuWIN V1.1 - Manual (Page 61)

56
E-mail: [email protected]
Website: www. X tramus.com
XTRAMUS TECHNOLOGIES
®
4.9.1 Frame Data Setup
The Frame Data is programmed by the following three types of data generators. They
are DA/SA, DIP/SIP, and Collision. The data created by each generator will overwrite
data created by earlier generators.
Select DA/SA, DIP/SIP, and Collision tab of the Frame Data dialogue to view their
individual property sheet.
4.9.1.1 Mask
Mask is a 6-byte (48-bit) value (in hexadecimal), which can be set to bind the range of
setting based on bit. The first two bytes are set to be fixed; the last four bytes can be set
as Mask value. The following table illustrates an example of XM-23L4 Mask fields
setting.
(Module Card: XM-23L4, DA: “0080 C8000501”, Mask: “XXXX XXXXXXXX”, Mode:
“Increase”, Loop count: ”10”, Loop step: “1”.)