AMETEK SLH Series RevC - Manual (Page 20)

Introduction Sorensen SLH-Series DC High Power Electronic Load
Dynamic frequency = 1 /(T HIGH + T LOW )
Duty cycle = T HIGH / (T HIGH + T LOW )
Figure 1-10 Dynamic Waveform
The load current level and load status can be set by either of two ways: manually, through
the front panel, or with GPIB command. The load input voltage and load current can be
read back to the computer through GPIB. (GPIB operation is described in Section 4).
1.2
FEATURES
• Full GPIB control of Load condition setting and meter read back
• Dual high accuracy & resolution 4-1/2 digit voltage and current meter
• Built-in pulse generator includes wide T
HIGH /T LOW dynamic load range, independent
Rise/Fall load current slew rate control, and High/Low Load Level
• Controllable load current Slew Rate of load Level change, load ON/OFF switch change,
and power supply turn-on
• Short circuit test and current measure capability, low short resistance and reliable short
circuitry is implemented by turn ON Power MOSFET and heavy duty relay
• Automatic voltage sense capability
• Full protection from over power, over temperature, over voltage, and reverse polarity
• Analog programming input capability at rear panel
• Isolated I-monitor BNC output, 10V full scale
1.3 ACCESSORIES
• V-sense cable: BNC-CLIP (1M) 1 ea.
• Binding Post Plug (Black) 1 ea.
• Binding Post Plug (Red) 1 ea.
• Hook terminal 2 ea.
• SLH-Series High Power DC Electronic Load operation manual 1 ea.
• Screws, M8x25
2 ea.
1-6 M540074-01 Rev C