AMETEK SLH Series RevC - Manual (Page 81)

Sorensen SLH-Series DC High Power Electronic Load Remote Programming
CURRENT Limit
Purpose:
To read the set value of upper/lower limit value of threshold current.
Command Syntax:
LIM:CURR{HIGH|LOW}?{;|NL}
Description:
LIM:CURR:LOW? Reads back the lower limit set value of threshold current; unit is
“amps (A)”.
POWER Limit
Purpose:
To read the set value of upper/lower limit value of threshold power(W).
Command Syntax:
LIM:POW{HIGH|LOW}?{;|NL}
Description:
LIM:POW:LOW? Reads back the lower limit set value of threshold power; unit is “watts” (W).
NG
Purpose:
To read the set value of NG.
Command Syntax:
NG?{;|NL}
Description:
NG? Reads back the condition indicating light of NG. “0” denotes that NG (NO GOOD) indicating
light has been extinguished. “1” denotes that NG indicating light has been lit.
PERIOD
Purpose:
The dynamic mode's Tlow or Thigh duration query command
Command Syntax:
PERI:{LOW|HIGH}?{NL}
Description:
PERI:LOW? returns the presently programmed low duration time in dynamic load mode
PERI:HIGH? returns the presently programmed high duration time in dynamic load mode
The engineering unit is “msec”.
RISE Time
Purpose:
The dynamic load mode's RISE slew rate query command
Command Syntax:
RISE?{NL}
Description:
RISE? returns the presently programmed low load current level in Constant Current mode
The engineering unit is “A/us”.
M540074-01 Rev C 5-19