AMETEK SLH Series RevC - Manual (Page 67)

Sorensen SLH-Series DC High Power Electronic Load Remote Programming
COMMAND SLH DC RETURN
MEASure:CURRent {?}{; ⎢NL} • ###.####
MEASure:VOLTage {?}{; ⎢NL} • ###.####
LIM:CURRent:{HIGH|LOW }{SP}{NR2}{;|NL} •
LIM:CURRent:{HIGH|LOW }{?}{;|NL} • ###.####
LIM:POWer:{HIGH|LOW }{SP}{NR2}{;|NL} •
LIM:POWer:{HIGH|LOW }{?}{;|NL} • ###.####
LIM:VOLTage:{HIGH|LOW }{SP}{NR2}{;|NL} •
LIM:VOLTage:{HIGH|LOW }{?}{;|NL} • ###.####
Table 5-6 Measure and Limit Commands
COMMAND SLH DC RETURN
GLOBal:[STATe:] PRESet{SP}{ON|OFF}{;|NL} •
GLOBal:[STATe:] LOAD{SP}{ON|OFF}{;|NL} •
GLOBal:[STATe:] MODE{SP}{ON|OFF}{;|NL} •
GLOBal:[STATe:] SHORt{SP}{ON|OFF}{;|NL} •
GLOBal:[STATe:] DYNamic{SP}{ON|OFF}{;|NL} •
GLOBal:[STATe:] LEVEL{SP}{HIGH|LOW}{;|NL} •
GLOBal:[STATe:] CC{SP}R2{;|NL} •
GLOBal:MEASure:CURRent{?}{;|NL} • ###.##
GLOBal:MEASure:VOLtage{?}{;|NL} • ###.##
Table 5-7 Global Commands
REMARKS:
1. d : 0 - 9
2. GLOB : GLOBAL (ALL CHANNELS ACTIVE AT SAME TIME)
3. CURRENT ENGINEERING UNIT : A
4. VOLTAGE ENGINEERING UNIT : V
5. RESISTANCE ENGINEERING UNIT :
Ω
6. PERIOD ENGINEERING UNIT : mS
7. SLEW-RATE ENGINEERING UNIT : A/
μS
Note
: The RS-232 command set is the same as the GPIB command set.
M540074-01 Rev C 5-5