AMETEK SLH Series RevC - Manual (Page 87)

Sorensen SLH-Series DC High Power Electronic Load Appendix B
B.3 Master and Slave System Connection
WARNING
Only qualified personnel are to perform system assembly.
B.3.1 System Assembly
Handles
1. Place the master on top of the slave unit.
2. Attach the handles to the left and right sides (Figure 1) using the screws provided.
The handles should protrude forward from the front of the units.
Rear Supports (applies to a two-unit configuration only)
1. From each unit, remove the six (6) screws on the rear panel (3 screws on the left and
3 screws on the right). Figure 1 shows the six screws for each of two units.
2. Align the holes of the rear supports (vertical angle brackets) with the screw taps on
the rear panels and screw into place (Figure 1).
CAUTION
Two people are required to lift the combined unit for a rack/cabinet installation.
The rear supports are for a 2-unit configuration only. Any system comprised of
three or more units must be installed into a cabinet.
M540074-01 Rev C B-3