Avalon Firestyles AGP Pellet - Manual (Page 16)

16
Installation
(For Qualified Installers Only)
© Travis Industries 4141230 100-01341
Mobile Home Requirements
 Outside air is required (used for combustion) - see the directions below.
DO NOT INSTALL IN SLEEPING ROOM.
CAUTION:
THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
Outside Air (Used for Combustion

Use Part #99200136)
Travis Industries strongly recommends outside air for all installations, especially for those with
relatively air-tight homes.
 Must not be drawn from an enclosed space (garage, unventilated crawl space).
 Must not be over 48” (1220mm) long
 Must be made with 1-¾” (45mm) diameter or larger metal or aluminum duct with a metal screen
attached to the end to keep out rodents (P.V.C. or other combustible materials may not be used).
We recommend the Travis Industries Outside Air Kit (part # 99200136 – additional duct may be
required).
 Must have a rain cap or down-turned elbow to prevent water from entering.
 Must be located so that it will not become plugged by snow or other material.
Outside air may be drawn
through the ash cleanout.
Seal this area with silicone
and/or insulation.
Outside air may be drawn from the chimney cavity.
Make sure to include an air opening at the top of the
chimney. Use a non-combustible block-off plate or
barrier (insulation) to seal the chimney from the
fireplace.
Maximum Outiside Air
Length is 48" (1220mm)