Avalon Firestyles AGP Pellet - Manual (Page 29)

Operation
29
© Travis Industries 4141230 100-01341
TSTAT (Thermostat) Mode
TSTAT mode allows you to use a thermostat to control room temperature. The insert automatically turns
on when the temperature drops below the thermostat setting and turns off (or to low) once the thermostat
setting is met.
Wireless thermostats are
available from Travis Industries.
See your dealer for details.
To Start the Insert in TSTAT Mode
Press the TSTAT button on the
control panel. If there is a call for
heat from the thermostat, the
insert will enter the start-up
sequence for approximately 22
minutes.
To Adjust the Heat Output
Use the HEAT knob on the control panel to adjust the heat output.
NOTE:
Depending upon which TSTAT Program
you are in (1, 2, or 3), the heat output
may vary once the target temperature is
reached. For details, see “Changing the
TSTAT Program” on page 30.
TIP:
If you find that the insert turns on and off
repeatedly, you may wish to turn the
heat output to a lower setting, which will
provide a more consistent heat output
over time, and eliminate the need for the
thermostat to repeatedly turn off the
insert.
To Shut Down
Press the STOP button on the control
panel. The insert will begin the shut-
down process, which takes about
approximately 45 minutes.