Avalon Firestyles AGP Pellet - Manual (Page 18)

18
Installation
(For Qualified Installers Only)
© Travis Industries 4141230 100-01341
3 Apply a bead of high-temperature RTV silicone to the chimney liner. Insert the chimney liner into
the slip connector and secure using (4) sheet metal screws. Apply additional RTV silicone to the
area around the connection to ensure an air-tight seal.
4 If using outside air, attach to the vent connector using a hose clamp.
5 Attach the vent connector to the insert. Make sure the silicone gasket attached to the bottom of
the vent connector is intact and remains in place.
Restrictor Adjustment
In certain installations with excessive draft, the restrictor will require adjustment to the closed position
(heater goes out on low or vent heights above 30’). Contact your dealer for details if you believe your
pellet insert is encountering excessive draft. Follow the directions below to adjust the restrictor to the
closed position.
To adjust the restrictor to
closed position:
a) Remove the burn platform.
b) Loosen the two screws.
c) Slide the restrictor down.
d) Tighten the screws.