Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 12)

11
When not threading the upper looper, the 2-thread converter
must be engaged into the upper looper eye.
Be sure to turn off power switch
Straddle the square part of the converter over the upper
looper and lower the converter till it lightly snaps into position.
See illustration.
To disengage the 2-Thread converter, raise the square end of
the converter and remove from the upper looper. See illustration.
To Use the 2-Thread converter
10. TO CONVERT UPPER LOOPER TO 2-THREAD
CONVERTER
To Disengage 2- Thread converter
To engage the 2-Thread converter, insert the point of the
converter into the back of the eye of upper looper.
Note: When using the upper looper, the 2-Thread converter must be
disengaged.
3
1
2
2
1
3
Caution: