Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 16)

15
3
3
2
2
8
6
7
9 5
4
2
3
1
1
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
pretension disc as
illustrated.
While holding thread with fingers, pass it between the tension
discs and pull thread down to make certain it is properly
located in between the tension discs.
1) Threading the (Green) Upper Looper
Open the front cover and thread the upper looper as indicated in
steps 1 through 9.
Pass thread from back to the front through thread guide.
- Raise the presser foot to release tension discs.
- Thread the upper looper area of the machine following the green
color-coded thread guides.
Caution: Be sure to turn off power switch.
To Thread The Machine Correctly
4
5
Place the thread from right to left into thread guide.
Place the thread from right to left and position thread behind
finger on thread guide.
3
2
1
4
5