Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 22)

21
Thread the eye of the right needle from front to back. Draw
about 10cm (4 inches) of thread through needle eye toward
the rear of machine and place thread to the back, under the
presser foot.
Note: Use tweezers provided in the accessory case to aid in
threading the looper.
5) Threading the (Red)
(D on needle clamp) CENTER NEEDLE
Chain Stitch Needle
2
7
8 5
6
1
2
4
3
10cm
(4")
9
1
2
9
9
Thread the center needle as indicated in steps 1 through 9.
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
pretension disc as
illustrated.
Pass thread from back to the front through thread guide. 1
2
-Raise Presser foot to release Tension discs.