Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 27)

2
1
6
4 5
7
8
3
2
1
10cm
(4")
9
2
9
Cover Stitch Right Needle (Green)
26
(3) Threading the
(E on needle clamp)
Thread the eye of the needle. middle
Draw about 10cm (4 inches) of thread through needle eye to
hang free.
Place the thread to the back, and slightly to left under the
presser foot.
9
Thread the cover stitch right needle as indicated in steps 1
through 9.
- Raise presser foot to release tension discs.
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
pretension disc as
illustrated.
Pass thread from back to the front through thread guide. 1
2
Note: Use of tweezers in the accessory case will make needle
threading easy.