Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 67)

A
C
66
The following optional presser feet specially prepared for this
machine are available at your local retailer.
Note: Do not use presser feet made for other machines. Use of
such presser feet may result in interference with the needle
and knife and can be hazardous.
The snap-on type presser foot of this machine permits easy
removal and replacement.
Caution:
Be sure to disconnect the power line plug or turn
off the power switch when changing the presser
foot.
Raise presser foot and raise needle bar to its highest position.
Press red colored lever (A) located on back of clamp under the
presser foot shank, raise presser bar to its highest position and
while holding the presser bar in this position, remove the presser
foot.
Place presser foot on needle plate under presser foot shank so
that hinge pin (C) will fit in slot (B) of the shank. Then lower
presser bar with lifter.
If presser foot can not be attached to presser foot shank easily,
raise presser bar lifter to its highest position and while holding it
in this position, place presser foot under the presser foot shank.
Then lower presser bar.
Raise presser bar and make sure the presser foot is properly
attached to the presser foot shank.
Removal
Replacement
29. SNAP ON PRESSER FOOT REMOVAL/
REPIACEMENT
Snap-On Type Presser Foot
C
B