Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 18)

17
Thread the looper eye (A) from front to back. Pull about
10cm (4 inches) of thread and position into V cutout (B)
on threader. Firmly hold thread tail with left hand and pull
threader lever (C) up to place thread into correct position
(D) for sewing.
Note: Use tweezers provided in the accessory case to aid in
threading the looper.
While holding thread with finger, pass it between the tension
discs and pull thread down to make certain it is properly
located in between the tension discs.
Place the thread from right to left into thread guide.
Thread the looper area of the machine following the blue color
coded thread guides 4~10.
Place the thread from right to left into thread guide.
4
6
5 7
8
9 10
A
B
C
D
10cm
(4")
C
L
4
5
6
7
8
9
10
3
3
3
4
5
6
7
8
9
10
Thread the balance of the lower looper area of the
machine following the blue color-coded thread guides,
placing thread in guides.