Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 17)

9
8
9
5
4
8
6 7
10cm
(4")
2
2
9
1
6
8
7
3
10
4
5
2
1
C
L
16
Open the front cover and thread the lower looper as indicated in
steps 1 through 10.
Thread the balance of the upper looper area of the machine
following the green color coded thread guides.
Note: Use tweezers provided in the accessory case to aid in
threading the looper.
- Raise presser foot to release Tension discs.
- Turn the handwheel toward you until the lower looper eye
extends out 5-10 mm from the needle plate edge.
- Thread the lower looper area of the machine following the bule
color-coded thread guides.
2) Threading the (Blue) Lower Looper
6
7
8
Thread the hole in the upper looper from front to back. Make
sure thread passes behind lower looper. Pull about 10cm
(4 inches) of thread through the looper and place to the back
of the needle plate.
9
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
pretension disc as
illustrated.
Pass thread from back to the front through thread guide. 1
2
Turn the handwheel toward you until the lower looper extends
out 5~10mm from the needle plate edge.