Baby Lock Diana (BL480A) Instruction and Reference Guide - Manual (Page 19)

Chain and Cover stitch Looper
Open the front cover and thread the chain stitch/ cover stitch
looper as indicated in steps 1 through 11.
3) Threading the (Purple)
18
3
L
C
1
2
3
4
5
6
7
8
9
10 11
1
2
3
2
While holding thread with finger, pass it between the tension
discs and pull thread down to make certain it is properly
located in between the tension discs.
3
- Raise presser foot to release Tension discs.
- Turn the handwheel toward you until the chain stitch looper
eye extends out 5-10 mm from the needle plate edge.
- Thread the chain looper area of the machine following the
purple color-coded thread guides.
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
pretension disc as
illustrated.
Pass thread from back to the front through thread guide. 1
2