ChamSys MagicQ Software Change Log - Manual (Page 127)

MagicQ Software Change Log 113 / 121
74.1.4 Console Wing IDs
When using MagicQ consoles with multiple Playback / Extra Wings (or multiple Execute Wings) it is now possible to set a Wing
ID for each Wing. The required wing ID can then be set in Setup, View Wings to ensure that the Wings are identified correctly
and control the correct Playbacks. Previously Wings could swap over if one was reset or they were powered on in a different
sequence.
Note that the Wing ID is only supported on new Wings with the most recent Wing firmware). The Wing ID is set by holding the
reset button under the armrest of the Wing whilst holding the lower most Page UP and Page Down buttons.
74.1.5 Other Changes
Colour scheme. The yellow colour scheme is now being obsoleted. It is still selectable for use in extreme sunlight conditions,
but will be reset to the normal colour scheme when a new show is loaded.
74.2 Bug Fixes
The . Button did not work on the remote devices such as iPhone/iPad/Android.
Fixed problem with lamp on/off/reset shortcuts introduced in 1.5.0.1. The shortcuts erroneously affected all heads rather than the
selected heads.
Improved prompts on remote devices to explain that pressing 1 confirms yes, whilst pressing 0 is no.
Fixed bug with morphing from a head with CMY (or RGB) but no colour wheel to a head with CMY (RGB) and a colour wheel.
The Cyan base levels would get copied to the Colour Wheel. Any FX on Cyan(Red) would be changed to be on Col 1 rather than
Cyan.
Fixed problem with timecode over ArtNet in recent versions. The messages sent and received were incorrect and caused the
times to be confused. This is fixed in 1.5.0.2, but both the transmitting console and the receiving console must be upgraded.
#0001769
Fixed problem with the Magic Wand support. From versions 1.4.9.1 to 1.5.0.1 only Magic Wand II protocol would work. Now
both protocols are supported.
Fixed problem with Execute Wing set with the top buttons in Execute Mode. The flash function did not work correctly. #0001644
Fixed problem with buttons on Extra Wings or Execute Wings when the flash button is set to toggle and there is a release time.
#0001729 Version 1.5.0.1
74.3 New Functions
It is now possible to morph heads from a multi part head to a head with a single part e.g. from Pixeline 1044 to generic LED, or
from Showtec sunstrips to Generic Dimmer. Note that it is not yet possible to morph from single part head to multi part head.
Added keypad shortcuts for lamping on/off and reset. These shortcuts also work on the ChamSys Remote app on iPhone/i-
Pad/Android. Select the heads and then
*++ Lamp on selected heads *-- Lamp off selected heads *// Reset selected heads
Mark Cues are now indicated more clearly with highlighting.
When setting fade times in the Cue Stack when a Cue already contains some fade times, then only attributes (Pos, Colour, Beam,
FX) times that are non zero are changed.