ChamSys MagicQ Software Change Log - Manual (Page 29)

MagicQ Software Change Log 15 / 121
Fix to absolute FX when run at less than 100% size so that base is added back in - avoids e.g. positions defaulting back to 0,0.
#0007923
Fix for Cue Stacks using "one shot" FX - the "one shot" FX would affect FX in following Cues. #0007634
Fix for removing items from MagicVis - previously when using Stand Alone MagicVis the items would not be removed from the
actual Visualisation until other items were added/moved.
Fix for Intensity Window Palettes View - the encoders and soft buttons would operate on Preset Intensities not on Programmer
Intensities. #0009501
Fix for using Intensity Palettes in the Execute Window.
Fixed Encoder E in Cue Window leaving behind data in the input window #0008764
Fixed problems with channels set to non track HTP or LTP on Cue Stacks set as all chans controlled LTP. HTP channels would
not be released. #0007060
Added work-around for problem with selection of heads in Capture Visualiser. Added support for sub selection when selecting
in Capture Visualiser #0005013
Fixed problem with Snapshots from Capture Visualiser - previously they always appeared black. #0008647
Fixed focus position selection from Capture Visualiser when using pan/tilt offsets. #0008449
Added work-around for BLIND mode in Capture Visualiser. #0008317
Fixed response of Media Window - most noticeable on MQ60.
6.2.1 MagicHD
Movement of media by scale, position or rotate is now smoother than before.
Scrolling within a layer using the scroll FX is now smooth (it was limited to 256 positions).
Added two new modes to the Mask colour effect so that a mask can be used with just the transparency coming from the original
media, and none of the colour (or a fixed colour). This means that (for example) grey-scale images used for edge blending don’t
colour the black areas of the layer below.