CREATOR CR-PGMIII - Manual (Page 17)

CREATOR CHINA 2011-03 WWW.CREATOR1997.COM
10 PGMⅢ Programmable Ethernet Control System
e.g.: 192.168.2.1
Subnet Mask：fill in the Subnet Mask, such
as: 255.255.255.0
Except the above mentioned settings, all the
other value can be set as 0,which include Default
Gateway, Primary DNS and the Secondary DNS
Click “Save Setting” to save and finish the
settings.
3.1.1.2 Wireless Settings
Img. 3-10
The wireless setup page is shown in Img. 3-10.
For setting up the wireless network the control
system, only the following items should be
changed, while other items should be kept as
their default value.
1,Basic Wireless Settings
Basic Settings：to setup the basic
prosperities of the wireless network.
Wireless Network Mode：the following
options are available:
Disable：to disable the wireless connections
B-Only：B Mode: the max speed of the
wireless transmission is 11Mbps.
G-Only：G Mode: the max speed of the
wireless transmission is 54Mbps
Mixed：Self-adaptive mode
This option is recommended, then the device
can self-adjust and choose the best suitable
mode according to the network card connected.
Wireless Channel：Choose the right channel
here. The default amount of the channels is 6. For
the detailed settings, please refer to Section
3.1.1.3 in this chapter.
SSID Name：The log in name used for
wireless local network identification. Only the ID
passed the identification can access the wireless
network. As shown in the image, this device
supports 4 SSID, and the SSID name can be
customized.
SSID Broadcast：Enable should be set here
for the other devices to detect the AP.
Click “Save Settings” to finish the settings.
2, Wireless Security Settings
Img. 3-11
Wireless Security ： Security parameters
can be set here: set a key and enable WEP,
or WPA, WPA2 encryption to reject the
unauthorized access to the network.
As shown
in Img. 3-12.
Select SSID：select an SSID and set its
security mode. The image shows the security