CREATOR CR-PGMIII - Manual (Page 25)

CREATOR CHINA 2011-03 WWW.CREATOR1997.COM
18 PGMⅢ Programmable Ethernet Control System
Chapter, Software Introduction
7.1 Think Control 1.0
Programming Software
The Think Control 1.0 programming software is
designed for programming for the CREATOR third
generation controller: the CR-PGMIII.
PC OS Requirements
This programming software can run on Windows
XP, VISTA, and WIN7.
7.2 Think Control 1.0 Installation
The Think Control 1.0 programming software is
available in the disk in the CR-PGMIII’s package.
It can also be downloaded from the web address
at:
http://www.creator.com.cn .
The installation procedures are as following:
Double click the installer to launch the installation,
as shown in the image:
Click Next:
Click Next again.
Choose your preferred language, and click Next.