Daktronics Aquatics Interface with Daktronics Matrix Displays - Manual (Page 26)

22 Daktronics Matrix Displays with Omega Timing Systems
3. The Enter Port Parameters window will
open (Figure 39).Type the name of the
input, for example Omega #1.
Under Port Type: select COM Port. Select
the Com Port that the timer is connected
to and configure the Baud to 9600, Parity
to Even, Data Bits to 7 and Stop Bits to 2
(Figure 40).
4. Click OK and the note shown in Figure
21 will appear. Click OK. After
configuring an input, shut down the
TimerInterface 2000 program and then
re-start it for all of the settings to take
effect.
5. After opening the Timer Interface 2000
program again (Figure 41), click Add
under the OUTPUTS: section.
6. The Configure Output: window will open
(Figure 42).
From the Select Input: section, select the
input to get data from. (Example: 1:
Omega #1 – Com 5,9600,7,Even)
Under Select Output Type: select Venus
7000 Direct. Next, click on the Edit
button under Select Port.
7. Use the spinner control to select the
Venus 7000 RTD input to send data to
and click OK.
8. Click OK in the Configure Output:
window to accept the new settings.
9. The note shown in Figure 21 will appear.
Click OK. After configuring an output,
shut down the TimerInterface 2000
program and then re-start it for all of the
settings to take effect.
Figure 39: Enter Port Parameters
Figure 40: Enter Port Parameters
Figure 41: TimerInterface 2000 with Input
Figure 42: Configure Output: