Section 1: introduction, 1 manual contents, Section 1 – Daktronics Aquatics Interface with Daktronics Matrix Displays User Manual
Page 5: Introduction, Manual contents
Introduction
1
Section 1:
Introduction
This manual explains aquatics interfaces with Daktronics matrix displays and includes the
following sections:
Covers the basic information about the program and this manual. Take time to
read the introduction as it defines terms and explains concepts used throughout
this manual.
Briefly explains the setup, configuration and connections involved with the
OmniSport 2000 timing system.
Explains the setup, configuration and connections involved with a
Colorado Timing Systems.
Describes the setup, configuration and connections involved with an
Omega Timing Systems.
Illustrates how to create RTD sequences
Offers details about who to contact for help with an application and information
about the Exchange Program and the Repair & Return Program.
Contains drawings for system applications.
1.1 Manual Contents
This manual describes the data entries to send scoreboard data to a Daktronics system.
Included are instructions for Hy-Tek, TimerInterface 2000, and SwimDive Request II when
used with Daktronics, Omega, Colorado and generic timers. For other questions concerning
this system, please contact Daktronics.
Listed below are a number of drawing types commonly used by Daktronics, along with the
information that each is likely to provide. This manual may not contain all of these drawings.
Figure 1 illustrates a Daktronics
drawing label. The drawing number
is located in the lower-right corner of
a drawing. In the example, the
drawing would be referred to as
Drawing A-69945.
Please list the model and serial
number, and the date received in the
blanks provided on the front page of this manual. When calling Daktronics customer service,
have this information available to ensure the request is serviced as quickly as possible.
Figure 1: Daktronics Drawing Label