Intel amt settings – DFI PT631-IPM User Manual
Page 141
141
6
Intel AMT Settings
8. Select Change ME Password then press Enter.
You will be prompted for a password. The default password is “admin”. Enter
the default password in the space provided under Intel(R) ME Password then
press Enter.
8-32 characters
•
Strong 7-bit ASCII characters excluding {
•
: , and ”} characters
At least one digit character (0, 1, ...9)
•
At least one 7-bit ASCII non alpha-numeric character, above 0x20, (e.g. !,
•
$, ;)
Both lower case and upper case characters
•
Note:
‘_’ (underscore) and ‘ ‘ (space) are valid password characters but are not
used in the determination of complexity.
[ESC] : Exit
[ENTER] : Access
[
↑↓
] : Select
[
INTEL(R) ME PLATFORM CONFIGURATION
]
Intel(R) ME State Control
Change ME Password
Password Policy
Network Setup
Activate Network Access
Unconfigure Network Access
Remote Setup and Configuration
FW Update Settings
Intel(R) Management Engine BIOS Extension v6.0.3.0014/Intel(R) ME v6.0.0.1184
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
Intel(R) ME Password