Digi-Star EZ 3200/EZ 3200V/EZ 3200V RC - Manual (Page 11)

Digi-Star Model EZ3200/EZ3200V/EZ3200V RC 5. Getting started
8
! copyright - 10/24/2001
5. Getting started
To operate the scale, first attach the scale's power cord to connector J901 and the loadcell cable to
connector J902 on the bottom panel of the scale.
Press the key. A brief message is displayed (such as HELLO ).
The scale enters the GROSS mode.
A warm up period of ten to fifteen minutes provides the most accurate readings. If the scale is
holding a load for a long period of time (ex. overnight), the weight displayed may vary because of
zero shift created by changes in temperature. This does not affect the accuracy of the scale.
For example, if the system was loaded with 1000lbs, it might read 1200lbs the following day. The
change in temperature "zero shifted" the ZERO/BALANCE from 0 to 200lbs. When unloading the
scale, the display will count from 1200 to 200lbs for a total of 1000lbs.
After this warm up period, press and release
. Then, within three seconds, press
.
The word ZERO is displayed to show completion of the ZERO/BALANCE step.
Now the scale is ready to weigh!
HELLO