Digi-Star EZ 3200/EZ 3200V/EZ 3200V RC - Manual (Page 18)

Digi-Star Model EZ3200/EZ3200V/EZ3200V RC 6. System operation
15
! copyright - 10/24/2001
TO USE THE PRE-ALARM The Pre-Alarm feature is an "early warning" for
the preset. For example, if the Pre-Alarm is set for
Weight with a value of 100 and the preset is 1000,
the preset alarm will flash during the last 100
lbs/kgs of the preset. The Pre-Alarm can also be set
to activate at a percentage of the preset instead of
a specific weight value. The alarms are continuous
once the preset is active. A Pre-Alarm provides an
early warning before reaching the preset which
allows the operator to be more accurate.
TO CHANGE THE PRE-ALARM VALUE 1. Go to Menu 4 of the Long Form Setup and
locate the P-MTHD Feature (see page 14: To
enter the Long Form Setup ).
2. Press to select either weight or percnt. The
indicator will flash the CAL annunciator.
3. Press to store the setting. The Pre-Alarm
Feature (p-alm) is displayed next.
4. Press to erase the current weight value.
The [Clear] key erases one digit at a time.
Continue to press the [Clear] key until 0 (zero)
is displayed.
5. Use the numeric keypad to enter a Pre-Alarm
Weight.
"""""!" Set the pre-alarm value to 0 (zero) to
prevent the alarm output from pulsing!
6. Press to store the setting.
7. Press and hold and then press to
return to normal Weighing Mode.
100
p mthd
5
2
5
3/6
4