Digi-Star EZ 3200/EZ 3200V/EZ 3200V RC - Manual (Page 22)

Digi-Star Model EZ3200/EZ3200V/EZ3200V RC 6. System operation
19
! copyright - 10/24/2001
TO PROGRAM A NEW RECIPE Before programming a new recipe:
" Set the desired entry method (see page 20: To
change the entry method ).
" Rename ingredients as needed (see page 29:
To rename ingredients ).
1. Press and hold and then press .
Continue holding both keys until the indicator
beeps and the scale displays the message
progrm.
The scale then displays either the first recipe
number programmed
REC-01 or REC- indicating that
a recipe number can be entered.
2. Press .
3. Use the numeric keypad to select the recipe
number.
4. Press
to enter the recipe number.
The EZ3200 then displays a message indicating
the entry method to be used:
- enter values in amount per Animal
- Enter values in percent per Load
- Enter values in Amount per Load
The message ING-__ is displayed immediately
following the entry method message.
5. Use the numeric keypad to select the
ingredient number. See Appendix 1 for
ingredient look up table with alpha names.
6. Press .
! Ingredient numbers do not have to be in
sequence.
The ingredient name (e.g. corn- 1) will be displayed followed by AMOUNT . Next the prompt for the
ingredient amount is displayed- YY:XXXX (e.g. 01: 5.00).
The first two digits, YY represent the ingredient number. The last four digits, XXXX represent the
amount for this ingredient.
progrm
rec- _ _
4
2
3
3
ing-_ _
6
5
5
and
1
1