Digi-Star EZ 3200/EZ 3200V/EZ 3200V RC - Manual (Page 20)

Digi-Star Model EZ3200/EZ3200V/EZ3200V RC 6. System operation
17
! copyright - 10/24/2001
TO START THE ROTATION COUNTER There are two ways to start the Rotation Counter.
Method 1
1. Press
to see the rotation count currently
set.
2. Press the and keys to change the
displayed value. The [Select] key increments
the "flashing" digit and the [Function] key
selects which digit of the display is flashing.
3. When the correct count has been entered or if the number displayed is acceptable, press
or to set the count and start the Rotation Counter.
The display now reads REV XX, showing the number of rotations remaining. The Motion
annunciator will flash when pulses from the Rotation Sensor are detected.
Method 2
1. Use the numeric keypad to enter the number of
rotations to count.
2. Press to enter the count and start the
Rotation Counter. The display now reads REV
XX, showing the number of rotations remaining.
The Motion annunciator will flash when pulses
from the Rotation Sensor are detected.
TO CLEAR THE ROTATION COUNTER
Press either , ,
or .
The scale clears the Rotation Counter alarms and
enters the Weighing Mode. The Rotation Counter
will continue to count rotations past 0 (REV -4,
negative numbers) until it is cleared.
TO RESTART THE ROTATION COUNTER
Press twice without entering a numeric value
to start the Rotation Counter using the count
previously entered.
REV 25
1
1
2
or
25
2×
25
1
2
2
3
3
or
Rev -4