Exacq exacqVision Virtual User Manual - Manual (Page 18)

www.e x acq.com
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
Page 18 of 44
4/12/2013
A new device should now be displayed in the /sys/bus/scsi/devices directory as 2:X:X:0, where X:X matches the virtual
device node of the drive you just created.
Type the command ls –l /dev/sd* to produce an output with the last line showing the new drive called /dev/sdd:
10. The exacqVision video storage should be mounted in the directory /mnt/edvr/# where each # is associated with a
label attached to a storage device. Use the ls/mnt/edvr command to view the number of mount points. You must
create a new mount point, incrementing # to the next number. The full path of this new directory will be used as the
label for the device.
ls /mnt/edvr
sudo mkdir /mnt/edvr/2
ls /mnt/edvr