Exacq exacqVision Virtual User Manual User Manual
Page 20
www.e
x
acq.com
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
Page 20 of 44
4/12/2013
14. Press CTRL+O and then press Enter to save the file. Press CTRL+X to exit the editor.
15. Re-read the fstab file by typing this command:
sudo udevadm trigger
16. Mount the drive using the drives label, which is the same as the mount point:
sudo mount /mnt/edvr/2
17. Verify the new drive by using the command df. The last entry should be your new drive. In this example, we added a
500GB drive mounted at /mnt/edvr/2.
18. The exacqVision Service must be restarted to see the new drive:
sudo /etc/init.d/edvrserver restart
19. Open up the exacqVision Client, click on the Config (Setup) icon
, and navigate to Storage. The new drive
should be displayed and enabled for storage.