Flowserve MX Electronic Actuator - Manual (Page 2)

Limitorque MX Electronic Actuator FCD LMENIM2306-06 – 10/13
2
Contents
1 Important Notes 7
2 Quick Start 9
2.1 Calibrate – Position Limits 9
2.1.1 Entering the Setup Mode 10
2.1.2 Electrical Operation Feature 10
2.1.3 Handwheel Operation Feature 11
2.2 DDC/Modbus Option 13
2.3 Check the Settings 13
3 Installation and Operation 14
3.1 Preparing the Stem Nut 14
3.1.1 Type “B” Bases: Torque-only Applications 14
3.1.2 Type “A” Bases: Thrust-only Applications 16
3.1.3 Type “BL” Drive: Splined Drive Application 20
3.2 Mechanical Installation Onto Valve or Gearbox 20
3.2.1 Mounting (Type “B” Bases): Torque-only 21
3.2.2 Removal (Type “B” Bases): Torque-only 21
3.2.3 Mounting (Type “A” Bases): Thrust-only 21
3.2.4 Removal (Type “A” Bases): Thrust-only 21
3.3 Electrical Connections 22
3.3.1 Removing Terminal Cover 22
3.3.2 Terminal Compartment Documents 22
3.3.3 Sealing Cable/Conduit Entries 22
3.3.4 Recommended Terminal Connections 22
3.3.5 Termination of Cables 24
3.3.6 Cable Connections 24
3.3.7 Network Installations 24
3.3.8 Foundation Fieldbus Installation 28
3.3.9 Network Wiring – Profibus DP/PA Installation 29
3.3.10 Network Wiring – DeviceNet 29
3.3.11 HART Installation 30
3.3.12 Replacing Terminal Cover 30
3.3.13 External Earth/Ground Connections 30
3.4 Terminal Block Shield Installation 30
3.5 Commissioning the Actuator 30
3.5.1 Default Configuration Set 31
3.5.2 View the Existing Settings 32
3.5.3 Entering the Setup Mode 32
3.5.4 Setting Position Limits 33
3.6 Operating the MX Actuator 36
3.6.1 Manual Operation 36
3.6.2 Electrical Operation 36
3.6.3 Local Control 36
3.6.4 Remote Control 37
3.6.5 Local Indication 37
4 Customizing the Actuator 38
4.1 Changing the Existing Settings 38
4.2 Password Entry 41
4.3 New Password 41
4.4 Valve Setup 42