MicroE Mercury II 6000V - Manual (Page 41)

Page 19
PurePrecision ™ Tape Scale Installation
By Applicator Tool
Section B - PurePrecision ™ Tape Scale Installation
Approx.. 25mm (1 inch) of exposed
layer of the tape scale emerging out
from the bottom
of the applicator tool
B6.2.5
Once the 2 layers have been inserted into the
correct slots, push the tape scale slowly into
the Applicator Tool until the adhesive liner
emerges from the right side of the Applicator
Tool as shown.
NOTE:
Do not pull on the adhesive liner.
It will automatically curl out.
Push the tape scale further into the Applicator
Tool until no more than about 25mm (1 inch) of
exposed tape scale emerges from the bottom
of the tool.
B6.2.6
Before installing the tape scale on your mounting
surface, hold the tool as shown. This will ensure
that a consistent pressure is applied to the tape
scale as it is being applied to the mounting
surface.
Place thumb at the center (use the grips provided
as reference) on one side.
Place index finger at the center on
top surface.
Place middle finger at the center
(use the grips provided as reference)
on the other side.