MicroE Mercury II 6000V - Manual (Page 62)

Page 7
Index being removed from the
perforated sheet by holding it
by its handle.
Index and Limit Marker Installation
Linear Glass Scales
Put on finger cots before starting the
index and limit markers installation.
C2.0
NOTE:
Remove the Limit and Index Markers from the
perforated sheet slowly to avoid premature
detachment of the markers from the handles.
Removing the Index Marker from the
Perforated Sheet
Begin by holding the Limit and Index Marker
sheet so that blue protective film is on top
(facing you).
Starting from the handle, remove the index
marker from the perforated sheet by pressing
gently from behind with your finger as shown.
It should pull away from the transparent
adhesive liner. Holding only the handle, slowly
pull the index marker from the perforated sheet.
NOTE:
Be sure to hold the index and limit markers
by the handle only. The adhesive on the
handle can be touched, however be careful
not to touch the adhesive on the areas of
the markers that will be applied to the scale.
* USE FINGER COTS
* USE FINGER COTS
Section C - Linear Glass Scale Installation