OpenEye Gen5 NVR - Manual (Page 26)

26
N4 FRONT BEZEL INSTALLATION
The N4 is shipped with handles attached to the front of the unit. If you choose to mount the front bezel
to your recorder, you will need to remove the handles and attach the bezel before attaching the
rackmount rails.
1. Remove the two screws from each handle.
2. Install the include bezel clips and fasten with screws.
3. Align and slide the right side of the bezel into the right
clip.
4. Slide the left side of the bezel into the left clip.
5. Lock the bezel by turning the key counterclockwise.
TURNING ON THE NVR
1. Turn on the monitor and any external peripherals (ex. Printers, External Storage Devices, etc.)
connected to the NVR.
2. Turn on the Secondary Power Switch located in the rear of the NVR.
3. Press the Power Switch located on the front of the NVR.
4. The NVR will run a series of self-tests. After two or three minutes, a series of messages may be
displayed as the various hardware and software subsystems are activated. Under normal
circumstances, users should not be asked to respond to these messages. If asked to respond to
the messages (adding a Printer, Monitor, etc for the first time) follow the instructions carefully.
5. Startup is complete when the OpenEye NVR software is finished loading and displays the main
menu screen.
TURNING OFF THE NVR
1. Click Exit on the main menu screen of the NVR software.
2. Select Power Off from the list and click OK. The NVR may take several minutes to shut down
completely.
Caution
Always be sure to follow the proper procedures when turning off the power to the NVR.
NEVER disconnect the power to the NVR while it is still running or in the process of