Orion System OE392-10 System Manager TS - Manual (Page 19)

SMTS Technical Guide
VCM, VCM-X & VCB-X Controllers
19
Selecting Units and Viewing VCM, VCM-X & VCB-X Status Screens
My System Unit Selection
From the Main Screen, touch the
< My System>
icon.
The Selected Unit Screen will appear. See Figure 17.
NOTE:
If you have chosen the One to One Unit Connection
in the System Manager Settings Screen, this screen will
not appear. Instead, the unit’s Status Screen will appear.
Back
Selected Unit [Loop 1 - Unit 1]
1
GO
0 1 0
- - - -
+ + + +
Figure 17: Unit Selection Screen
In Figure 17, Loop 1 and Unit 1 are selected as indicated in the fi gure
with white text. They also appear in the Top Menu Bar in brackets.
Use the <+> and <-> buttons to move up and down through the loops
and units. Enter the desired Loop # and Unit # and then touch <GO>
to access the unit’s Status Screen.
NOTE:
Instructions for confi gurations and setpoints are included in
this guide separately for VCM/VCM-X Controllers, VCB-X Controllers,
and VAV/Zone Controllers. See page 25 for VCM/VCM-X Controllers,
page 35 for VCB-X Controllers, and page 51 for VAV/Zone Controllers.
Viewing VCM, VCM-X & VCB-X Status
Screens
Figures 18, 19, 20 & 21 depict the fi rst Controller Status Screens.
Notice that the controller is identifi ed by loop number and unit number
- in this case, 0102 represents Loop 1, Unit 2. Images vary based on
controller type.
Figure 18: VCM-X & VCM-X Modular Controller
Status Screen 1
Figure 19: VCM-X WSHP Controller (Tulsa) Status
Screen 1
While in the Status Screen, touch the <+> and <-> buttons to view more
status screens displaying relays and operating setpoints. These screens
roll back to the fi rst Status Screen.