Menu--- effects, Menu--- test pattern, Menu--- led card – RGBLink VSP 628S User Manual User Manual
Page 42: Menu--- system, Effects, Test pattern, Led card, System
VSP 628S User Manual 42
the knob to save the operation to User Mode 1 or User Mode 2 in the Save
subordinate options, then the LCD screen displays it is in the saving state;
Push Menu and exit Save. Rotate the knob to Recall and to load User
Mode1 or User Mode 2, then the LCD screen displays it is in the loading
state.
Rotate the knob and select EFFECTS in the Menu, then the LCD screen
displays the level 2 menu as follows:
TRANSITION MODE：Select transition modes. FADE SETTING can setup
（FADE IN/OUT）or （FADE TO BLACK）.
TRANSITION TIME：Setup transition time. Rotate the knob to select time
and push the knob to confirm. Transition time ranges from 0 to 50.
Rotate the knob and select TEST PATTERN in the Menu, then the LCD
screen displays the level 2 menu as follows:
TEST PATTERN TYPE: There are 14 kind s of test pattern: H RAMP, V
RAMP, 100% COL BAR, 75% COL BAR, 16*16 GRID, 32*32 GRID,
BURST, 50% GRAY, GRAY STEP 1, GRAY STEP 2, WHITE, BLACK,
SMPTE COL BAR, LOGO.
RASTER BOX.
DIAG MOTION.
AOI RASTER BOX: User can choose ON/OFF this function, the settings
including: BOX X, BOX Y, BOX WIDTH and BOX HEIGHT.
BRIGHTNESS: Control the brightness of sending card.（Only available for
DBstar sending card）;
CALINRATION: Calibrate sending card brightness.（Only available for
DBstar sending card).