RGBLink VSP 628S User Manual - Manual (Page 88)

6.
SYSTEM SETUP AND OPERATION
How to Realize LAN Remote Control Settings
VSP 628S User Manual 88
Secondly refer to router
’s instruction (user manual,specification), and find out router’s
default network segment.
If router
’s default network segment is 192.168.0.1, then it is same to processor IP address
segment, open up windows control software and user can directly control on VSP 628S.
If router
’s default network segment is 192.168.1.1, then user need to change router’s
default gateway or change processor
’s IP, both methods are available, but we suggest to
change processor
’s IP.
Method one: Change processor ’s IP.
Press MENU on front panel and go into items as below picture shows. Change
processor ’s IP to be 192.168.1.100, confirm and restart the processor, then user can
directly control on VSP 628S via windows control software.
Method two: Change router ’s gateway.
Type in 192.168.1.1 on the browser and go into router setting;
Type in default account and code (please refer to the router user manual for the